JX3-BN-EC

The JX3-BN-EC EtherCAT® bus node serves as a gateway between an EtherCAT® master and Bucher Automation JX3-I/O modules. JX3-BN-EC modules are used for the purpose of setting up remote I/O stations. They enable synchronous communication via EtherCAT® between the controller and remote JX3-I/O modules.

Features:

• Automatic addressing 
• CoE (CAN application protocol over EtherCAT®) is supported 
• Compliant with EtherCAT® Modular Device Profile 
• Synchronous communication via Distributed Clocks (DC Sync) 
• Connects to up to 32 JX3-IO modules (depending on module type) 
• LEDs indicate the state of communication and supply voltage.

Available expansion modules:

• JX3-DI16, 16 digital inputs, IEC 61131-2 type 3, pnp, pulse stretching, digital input filters, counter function 
• JX3-DIO16, 8 digital inputs + 8 multi-purpose I/Os, filter, pulse stretching, PWM, counter function, short-circuit detection 
• JX3-DO16, 16 digital outputs 24VDC 0.5A, PWM, short-circuit detection 
• JX3-AI4, 4 analog inputs, 16 Bits, -10V..+10V, 0..10V. 0(4)..20mA, scaling, averaging, limits monitoring, slave pointer, osciloscope 
• JX3-AO4, 4 analog outputs, 16 Bits, -10V..+10V, 0..10V, 0(4)..20mA, scaling, limits monitoring, slave pointer, osciloscope, table mode 
• JX3-THI2-RTD, 2 inputs for temperature measuring with PT-100/1000 sensor 
• JX3-THI2-TC, 2 inpuits for temperature measuring with thermocouple-type sensors
• JX3-DMS2, 2 inputs for a direct measurement of strain, force and pressure with load cells 
• JX3-CNT, counter module for single, dual or SSI channel counting
• JX3-MIX, multi-purpose expansion module comnbines digital, analog I/Os, counterinput and a stepper motor controller

The following device is certified by an official EtherCAT Test Center:

• JX3-BN-EC